新闻动态

新闻动态

创造产业新生态 构建发展新格局

How to maintain a planetary stirring frying pan?

The specific maintenance methods for planetary stirring frying pan are as follows:
1、 Each time the planetary stirring frying pan is used, each transmission component should be inspected and lubricant added to avoid dry grinding, which may cause equipment damage.  
2、 Check whether the electrical wiring is intact, whether the wiring and fuses are secure, and if everything is normal, then power on and heat up.  
3、 Before starting, check whether the amount of heat transfer oil added is 5cm below the oil injection port. Remember not to let water enter the oil filler. If there is a noise inside the pot during the heating process, drain the heat transfer oil and filter it again before continuing to use.  
4、 During the normal operation of the equipment, the two oil injection ports on the upper edge of the boiler body cannot be blocked after adding oil, and should be heated open for use.
5、 Check whether the fixing bolts of the handle are firm and avoid friction and leakage between the heating pipe wires and the pot body when rotating.  
6、 Workers cannot operate with water, and should immediately stop working when there is oil leakage outside.  
7、 During operation, the temperature should be strictly controlled. Generally, it should be controlled below 200 degrees Celsius.

Related news

What are the uses of the fully automatic planetary stirring frying pan?

The fully automatic steam planetary stirring frying pan is mainly applicable to the frying of conditioned foods such as central kitchens, chain hotel canteens, various fillings, hot pot bottoms, instant noodle sauces, chili sauce, etc.

How to replace the heating tube of the planetary stirring frying pan?

The heating tube is generally circular, and the heating end is fixed to the bottom of the pot with a nut encrypted seal ring.

How to maintain a planetary stirring frying pan?

Each time the planetary stirring frying pan is used, each transmission component should be inspected and lubricant added to avoid dry grinding, which may cause equipment damage.